Related Manuals for Hunter Anisten 52774
Summary of Contents for Hunter Anisten 52774
- Page 1 Anisten Installation Manual Model: 52774 Fresh White 52775 Matte Black Fan weight ±2 lbs: 14.1 lbs (6.4 kg) ©2023 Hunter Fan Co. PG4174 r110323...
- Page 2 - All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 3 We recommend that you pull everything out of the box and lay it out. We have grouped the drawn components below with the hardware you’ll need for those Hunter Pro Tip: parts. The screws below are drawn to scale to make it easier to identify what piece of hardware is needed to install each component.
-
Page 4: Choosing The Right Installation Location
A little more information on Angled Mounting: For optimum performance and appearance, a longer downrod should be used with your Hunter ceiling fan when installing on high or angled ceiling. If your ceiling is angled greater than 34° you will also need an Angled Mounting Kit. - Page 5 You have two options for installation. Pick which one works best for your location. Remove any existing Hunter Pro Tip: bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box. The machine screws are the ones that came with your outlet box.
-
Page 6: Hanging The Fan
1886 Installing the Downrod Follow below if you are using the downrod that came pre-assembled in your box. Need to install a longer or shorter downrod? Check out the guide at the end of this manual. DO NOT NOTICE REMOVE SETSCREW COMPLETELY To prevent damage to fan,... -
Page 7: Installing The Canopy
1886 Making Connections for the Receiver and the Fan From receiver From receiver From fan From fan Connect wiring harness from ceiling Connect both wiring harnesses from fan to Connect the grounding wire plug from the bracket to the wiring harness from the the wiring harness from the receiver. - Page 8 1886 Installing the Blades: Put the blade washers, found in the hardware bag, onto the blade screws, found in the hardware bag. Then install the blade screws to secure each blade to a blade iron. Repeat x5 Blade Screw IMPORTANT Washer NOTE: Follow the instructions on the blade.
-
Page 9: Assembling The Light Kit
1886 Assembling the Light Kit 2 of 6 1 of 6 Light Kit Screw Light Kit Screw Insert the third screw, found in the hardware Partially install two light kit assembly screws, bag, into place and then tighten all three screws. found in the hardware bag, halfway into Connect 3-pin to the plug connector found in the... - Page 10 1886 Installing the Pull Chains The fan pull chain controls the speed: from high to off. The light pull chain controls Repeat x2 the light fixture: on and off. Remove and discard the plastic connectors from the ends of the short pull chain.
-
Page 11: Troubleshooting
1-888-830-1326 use of improper parts or accessories, failure to provide maintenance to the fan, or acts of Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. God (e.g. flood). ORIGINAL PURCHASER’S SOLE AND EXCLUSIVE REMEDY FOR A CLAIM OF ANY KIND What Does This Warranty Cover? WITH RESPECT TO THIS PRODUCT SHALL BE THE REMEDIES SET FORTH HEREIN. - Page 12 1886 Downrod If you need a different downrod length follow these steps: Remove ball screw (A). Slide ball down (A), remove small metal pin (B) and ground screw (C). Remove ball (A), inner sleeve (B) and downrod (C) from fan body and wiring harnesses.