Advertisement
UD-301/351
DISASSEMBLY FOR REPAIR
*Remove the metallic cabinet from the body beforehand.
(1) Open the cassette holder by pushing the eject button.
Then, remove the front glass by pushing the hook
@ located inside the cassette holder by means of a
square-bard standard screwdriver and the like.
(2
If the tray doesn't come out even when the power
is turned ON, slide the lever located in side the CD
mechanism
with a slender screwdriver, a piece of
wire, etc., from the left-hand side of the front panel
e.
When the CD tray panel of the fornt panel comes out,
pull the tray out and then remove the tray panel @.
(X-B3 only)
Disconnect the flat cable.
Remove
the 4 screws @, and then remove
the rar
@
(4
panel.
Remove the 4 screws @, pull the deck printed cir-
cult board in the arrow direction, and then discon-
nect the connector
from the front printed circuit
board.
Remove the 6 screws @, and then remove the front
panel.
Remove
the 8 screws
@,
and
then
remove
the
mechanism
main unit and the spring.
Remove
the 2 screws @, and them
remove
the
(5
(6
{7
printed circuit board mounting fitting.
{8) The CD
mechanism
can
be removed
when
the 4
screws
@ are removed.
(Note 1)
Refer to DP-A5/AQ
for the mechanism
disassembling
method.
(Note 2)
REPAIRING THE CD UNIT
The FL indication goes out when the rear panel and the
cassette printed circuit board (X29-) are removed, but
the operation of the CD can be checked notwithstanding.
13
Advertisement
