Setting Up Remote Module And Powerhorn - X10 Orca2000 Owner's Manual

Setting up Lamp Modules
When the alarm trips, lamps connected
to Lamp Modules set to A-1 (or other
codes on request from the monitoring
station - see pages 10 and 11) flash on
and off for the duration of the alarm.
After 4 minutes (or when you stop the
alarm) the lamps stop flashing and
remain on.
You can also control Lamp Modules set
to A-1 from the LIGHTS ON and
LIGHTS OFF buttons on the Keychain
Remote, or from the small buttons under
the lid on the KR15A Panic Button.
Choose a lamp you want to be a part of
your Panic System. Make sure the
lamp's on/off switch is on and plug the
lamp into the Lamp Module. Plug the
Lamp Module into any convenient outlet.
Set the House Code and Unit Code dials
on the Lamp Module to A-1 (or other
codes on request from the monitoring
station - see pages 10 and 11).
Lamp Module
8
1
15
3
13 5
11 7
9
UNIT
A
O
C
M E
K G
I
HOUSE
Setting up the POWERHORN
The POWERHORN Remote Powerline
Siren responds to signals transmitted
by the Console (over your house wiring).
When you trip the panic alar m, the
POWERHORN is also tripped and
contin ues to sound until about 4
seconds after the alarm is stopped.
1. Set House Code and Unit Code dials
on the POWERHORN to A-1
2. Plug the POWERHORN into a
standard AC outlet (not one
controlled by a wall switch).
WARNING: THE POWERHORN is
very loud! Do not stand near it when
you trip the alarm. Prolonged
exposure could cause permanent
hearing damage.
1
15 3
13
11 7
9
UNIT
A
O C
M
K G
I
HOUSE
5
E
Power Horn