Scag Power Equipment V-RIDE II SVRII-32A-23BV Operator's Manual page 34

R
CUTTER DECK HEIGHT
The cutter deck height adjustment is made to ensure that
the cutter deck is cutting at the height indicated on the
cutting height index gauge. To check for proper deck height,
be sure that the mower is on a flat, level surface, shut off
the engine and remove the igition key. Make sure the tires
are properly inflated.
1. Check the cutter deck cutting height by placing the
lanyard pin in the 3" position on the cutting height
index. Release the deck from the transport position
and allow the deck to move to the 3" cutting height
position.
2. Rotate the cutter blade on the left side of the cutter
deck. Position the cutter blade so it is facing "front to
back" on the machine.
WARNING
Always wear proper hand and eye protection
when working with cutter blades.
3. Check the measurement from the floor to the cutter
blade tip at the front and rear of the left side blade.
If the measurement is not at 3", an adjustment must
be made using the cutter deck adjustment lever.
Adjust as follows:
A. Loosen the elastic stop nuts securing the deck
level links on the front and rear of the cutter deck. See
Figure 6-6.
B. Turn the adjustment bolts on the front and rear either
clockwise to raise or counterclockwise to lower the front
of the cutter deck until the measurements are equal.
Tighten the elastic stop nuts.
ADJUST HERE
Figure 6-6. Left Side Cutter Deck Adjustment
4. Rotate the cutter blade on the right side of the cutter
deck. Position the cutter blade so it is facing "front to
back" on the machine.
5. Check the measurement from the floor to the cutter
blade tip at the front and rear of the right side blade.
If the measurement is not at 3", an adjustment must
be made using the cutter deck adjustment lever.
Adjust as follows:
A. Loosen the elastic stop nuts securing the deck
level links on the front and rear of the cutter deck. See
Figure 6-7.
30
Section 6
LOOSEN HERE
ADJUST HERE