Table of Contents
Advertisement
FPLG2 Channel LOGO Vector Clip SW (SD)
FPLG3 Channel LOGO Vector Clip SW (HD)
Factory preset data will be loaded after setting Model ID data.
(Refer to Initialization of Memory Data of QA02 and setting data of signal board.)
Adjusting the Data
Pressing of VOLUME
FFH. The variable range depends on the adjusting item.
I2C Bus Off
Turn off I2C communication between IC700 and IC400.
1) Press and hold the CALL button on the remote control, then press the Volume
on the TV.
2) Display "BUS Off" OSD.
3) I2C communication turned off.
Note:
To return Bus on status, press and hold the CALL button on the remote control, then press
the Volume
button on the TV again. TV will be turned off and automatically turned on,
then status will be Bus On.
Setting TVOP
Enter to service mode and select menu of TVOP by pressing P
adjustment menu. After selecting TVOP, press
disable or enable as below.
TVOP
FUNCTION DESCRIPTION
D5 (bit5) I2C check between IC700 and IC400. (WDT) Disable Enable
file://C:\Documents and Settings\Alexsandr\Local Settings\Temp\Rar$EXa0.787\32W...
+/- button will change the value of data in the range from 00H to
or P
during display of
+ or
- to set I2C check function to
1
0 (Normal)
Стр. 5 из 18
button
02.05.2015
Advertisement
Table of Contents
