Table of Contents
Advertisement
Idle Time
MTU Size
Attain DNS
Automatically
Set DNS Manually
DNS 1
DNS 2
DNS 3
Clone MAC Address Fill in the MAC address that is the MAC address to
Enable uPNP
Enable Web Server
Access on WAN
Enable WAN Echo
Reply
Set TTL value
Apply Changes
Reset
setup the connection through PPPoE protocol
whenever you send the data packets out through the
WAN interface; there are a watchdog implemented
to close the PPPoE connection while there are no
data sent out longer than the idle time set.
Manual connection type means to setup the
connection through the PPPoE protocol by clicking
the Connect button manually, and clicking the
Disconnect button manually.
If you select the PPPoE and Connect on Demand
connection type, fill in the idle time for
auto-disconnect function. Value can be between 1
and 1000 minutes.
Fill in the mtu size of MTU Size. The default value is
1400. Refer to 4.23 What is Maximum Transmission
Unit (MTU) Size?
Click to select getting DNS address for PPPoE
support. Please select Set DNS Manually if the
PPPoE support is selected.
Click to select getting DNS address for Static IP
support.
Fill in the IP address of Domain Name Server 1.
Fill in the IP address of Domain Name Server 2.
Fill in the IP address of Domain Name Server 3.
be cloned. Refer to 4.24 What is Clone MAC
Address?
Click the checkbox to enable uPNP function.
Refer to 4.22 What is Universal Plug and Play
(uPNP)?
Click the checkbox to enable web configuration from
WAN side.
Click the checkbox to enable WAN ICMP response.
Click to Enable and set Time to Live value.
Click the Apply Changes button to complete the
new configuration setting.
Click the Reset button to abort change and recover
the previous configuration setting.
30
Advertisement
Table of Contents
