Table of Contents
Advertisement
Subnet Mask
Default Gateway
DHCP
DHCP Client Range Fill in the start IP address and end IP address to
Show Client
DNS Server
Domain Name
802.1d Spanning
Tree
Clone MAC Address Fill in the MAC address that is the MAC address to
Apply Changes
Reset
3.3.11 WAN Interface Setup
This page is used to configure the parameters for wide area network that
connects to the WAN port of your X-Micro WLAN 11g Broadband Router.
Here you may change the access method to Static IP, DHCP, PPPoE
or PPTP by click the item value of WAN Access Type.
Fill in the subnet mask of LAN interfaces of this
WLAN Access Point.
Fill in the default gateway for LAN interfaces out
going data packets.
Click to select Disabled, Client or Server in
different operation mode of wireless Access Point.
allocate a range of IP addresses; client with DHCP
function set will be assigned an IP address from the
range.
Click to open the Active DHCP Client Table window
that shows the active clients with their assigned IP
address, MAC address and time expired
information. [Server mode only]
Manual setup DNS server IP address.
Assign Domain Name and dispatch to DHCP clients.
It is optional field.
Select to enable or disable the IEEE 802.1d
Spanning Tree function from pull-down menu.
be cloned. Refer to 4.24 What is Clone MAC
Address?
Click the Apply Changes button to complete the
new configuration setting.
Click the Reset button to abort change and recover
the previous configuration setting.
25
Advertisement
Table of Contents
