Makita GTW01 Instruction Manual page 7

Battery power lamp
When the remaining battery capacity becomes low,
the battery power lamp blinks. Charge the battery or
replace the battery with fully charged one. When the
remaining battery capacity becomes much lower, the
tool stops and the battery power lamp lights up.
Fig.4
► 1 . Battery power lamp
Hook
CAUTION:
Be sure to attach the shoulder belt
included in the tool as the standard accessory.
Use the shoulder belt for carrying the tool, and
never use the hook for other purposes such as
the fall prevention at high location. If the hook is
used for other purposes, excessive load may break
them and cause serious injury to the operator and
person around/underneath the operator.
CAUTION:
When using shoulder belt, make
sure that the hook is securely fixed to the tool. If
the hook is loose, tighten the hook's screw to fix the
hook.
CAUTION:
When you attach the shoulder
belt to the hook, be sure to attach it securely. If it
is attached incompletely, the tool may come off and
cause an injury.
CAUTION:
When using shoulder belt, care-
fully inspect the hook for damage, cracks, or
deformation.
CAUTION:
When carrying the tool using
the shoulder belt, be careful not to entangle the
shoulder belt with your body or objects and not to
hit objects with the tool. Failure to do so may cause
an accident.
CAUTION:
Remove the shoulder belt from
the hook before operating the tool. Failure to do
so may lose your balance at operation and cause an
accident.
Attach the shoulder belt included in the tool as the
standard accessory to the hook for carrying the tool.
Remove the shoulder belt from the hook before operat-
ing the tool.
1
1
Fig.5
► 1 . Hook 2. Shoulder belt
Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at a Makita service
center.
Accidental re-start preventive
function
Even if you install the battery cartridge while pulling the
switch trigger, the tool does not start.
To start the tool, first release the switch trigger and then
pull the switch trigger.
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
according to the instruction manual. Otherwise
accessories may come off and cause injury.
Removing the outer and inner
sleeves
CAUTION:
ter to enter the insides of the tool when removing
or installing the outer and inner sleeves.
7 ENGLISH
Always be sure that the tool is
Be sure to install accessories
Be careful not to allow foreign mat-
2