Summit SCR600LOS SERIES Use And Care Manual page 11

Built-in under-counter refrigerators built-in under-counter freezers built-in wine cellars outdoor refrigerators and freezers indoor drawer refrigerators and freezers outdoor drawer refrigerators and freezers auto-defrost bi605ff series
Hide thumbs Also See for SCR600LOS SERIES:
Table of Contents

Advertisement

Felix Storch, Inc.
SUMMIT PROFESSIONAL DIV.
INSTRUCTIONS FOR INTEGRATED FRAME (SUFFIX 'IF') FOR BUILT-IN APPLICATIONS
Note: The directions below are for installation under a cabinet in a 24 inch cutout space. If you will be using this product in a
freestanding application, please skip below, and begin with step A1 in lower half of page.
1. Remove door from chassis by unscrewing 3 screws in top hinge and
2 screws in bottom hinge. Keep screws, discard hinges.
2. Remove top and bottom hinge bushings.
3. Remove frame from door.
4. Attach customer-supplied handle to door panel using countersunk
screws.
5. Screw door panel to frame using 14 screws.
6. Slide frame over refrigerator door and attach with 1 screw on each
side on center of door.
7. Attach top brace to frame with 1 screw on each side. Attach bottom
brace in the same manner.
8. Drill a hole through the top and bottom panel using the braces as a
guide with a 1/8" drill bit. Install screws to finish attaching the top and
bottom braces securely to the frame.
9. Drill a hole into the door panel from the top and bottom using the
braces as a guide with 1/4" drill bit. Do not exceed 5/8" deep. This is
the hole that the door will pivot on.
10. Remount the door using the supplied top and bottom hinges.
INSTRUCTIONS FOR INTEGRATED FRAME (SUFFIX 'IF') FOR FREESTANDING USE
A1. Remove door from chassis by unscrewing 3 screws in top hinge and
2 screws in bottom hinge. Keep screws, discard hinges.
A2. Remove top and bottom hinge bushings.
A3. Remove frame from door.
A4. Attach customer-supplied handle to door panel using countersunk
screws.
A5. Screw door panel to frame using 14 screws.
A6. Slide frame over refrigerator door and attach with 3 screw on
each side.
A7. Install top and bottom hinge bushings.
A8. Remount the door using the supplied top and bottom hinges.
Page 11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents