Toshiba EQUIUM M40 Maintenance Manual page 177

4.11 North Bridge thermal module
Installing the Removing North Bridge thermal module
Install the Removing North Bridge thermal module according to the following procedures
and Figure 4-31.
1. Place the north bridge thermal module in the correct position and push the clip in
correct position on the system board.
2. Secure two north bridge thermal module screws.
3. Connect the North Bridge thermal module cable to the CN511 on the system board.
4. Stick EMI tape on north bridge thermal module left and right side.
EQUIUM M40/M45 / Satellite M40/M45 Maintenance Manual
4 Replacement Procedures
4-43