Table of Contents
Advertisement
48
en | Configuration
Enter the appropriate password for authentication.
Privacy protocol
Select the appropriate privacy protocol: None, DES, or AES.
Privacy password
Enter the appropriate password.
Read-only
To make this information read-only, select this check box.
Quality of service
The camera offers Quality of Service (QoS) configuration options to ensure fast network
response to PTZ data and images. Quality of Service (QoS) is the set of techniques to
manage network resources. QoS manages the delay, delay variation (jitter), bandwidth, and
packet loss parameters to guarantee the ability of a network to deliver predictable results.
QoS identifies the type of data in a data packet and divides the packets into traffic classes
that can be prioritized for forwarding.
Consult with your network administrator for assistance configuring the Video, Control, and
the Alarm video settings, and to select the appropriate Post-alarm time.
Post-alarm time has a time period from 0 s [seconds] to 3 h [hours]; 15 s [seconds] is the
default option.
Click Set to apply the changes.
Some changes only take effect after the unit is rebooted. In this case, the Set button
changes to Set and Reboot.
5.7.5
Multicast
The device can enable multiple receivers to receive the video signal simultaneously. The
stream is either duplicated and then distributed to multiple receivers (Multi-unicast), or it is
sent as a single stream to the network, where it is simultaneously distributed to multiple
receivers in a defined group (Multicast).
Multicast operation requires a multicast-enabled network that uses UDP and the Internet
Group Management protocol (IGMP V2). The network must support group IP addresses.
Other group management protocols are not supported. The TCP protocol does not support
multicast connections.
A special IP address from 225.0.0.0 to 239.255.255.255 (class D address) must be
configured for multicast operation in a multicast-enabled network. The multicast address
can be the same for multiple streams, however, it is necessary to use a different port in
each case.
The settings must be made individually for each stream. Enter a dedicated multicast address
and port for each stream.
The video channels can be individually selected for each stream.
Enable
Enable simultaneous data reception on receivers that need to activate the multicast
function. To do this, check the box and enter the multicast address.
Multicast Address
Enter a valid multicast address to be operated in multicast mode (duplication of the data
stream in the network).
2024-02 | V01 | DOC
User manual
DINION 3100i IR
Bosch Security Systems B.V.
Advertisement
Table of Contents
