Rear Panel; Instructions For Using The Interactive Operation Interface - Monacor RELACART MIXX12-D Installation And Operation Manual

Rear panel:

1. AC power interface: Install the factory-configured power cord and connect 110V-240V
50 / 60Hz AC power.
2. Power switch: I / O boat switch, press I to turn on the power, press O to turn off the
power.
3. RESET: Press and hold for 3 seconds to reset DANTE network IP address:
192.168.1.120, press and hold for 6 seconds to reset DANTE network IP + WIFI reset.
(Please refer to WIFI reset parameter setting after resetting WIFI)
4. DANTE network interface: The DANTE interface can transmit audio through the
network, and can also control the mixer through software.

Instructions for using the interactive operation interface

MIX
GAIN
SYSTEM
INPUTS OUTPUTS
Analog Analog Analog Analog Analog
GATE/COMP GATE/COMP GATE/COMP GATE/COMP GATE/COMP
SENDS SENDS SENDS SENDS SENDS
MUTE MUTE MUTE MUTE MUTE
SOLO SOLO SOLO SOLO
CHANNEL 1 CHANNEL 2 CHANNEL 3 CHANNEL 4 CHANNEL 5
1. MIX / GAIN function switch: A switch that switches the fader to control channel level or
control channel gain.
2. Input channel 1-12 window: display the fader status and input level display of channels
1-12. Click to switch to the input channel page.
3. Output channels AUX 1-AUX 4, DANTE 1-DANTE 4: display output channels AUX 1-
AUX 4, DANTE 1-DANTE 4 The fader status and output level are displayed. Click to
switch to the output page.
4. Software communication status: The icon lights up in blue to indicate online, and gray
to indicate offline.
5. Group function: You can edit mute group and control group to make the channel function
work synchronously.
6. 48V phantom power interface: can independently control phantom power for channels
1-6.
7. Effect parameter setting interface: You can set the effect parameters of reverb and echo.
8. Clear mute switch: Mute all channels that are muted.
9. Clear monitoring: Turn off monitoring for all channels that have monitoring enabled.
10. Performance saving: You can save the set parameters to the performance interface,
and use the saved scene next time after the software connects and communicates
directly.
11. System setting interface: You can enter the connection page, and you can update the
firmware.
12. Main output channel: You can control the function of the main output channel.
13. Function status display window: It is displayed in three lines, the channel currently
being set in the first line, the parameters of the function currently set in the second line,
and the function currently set in the third line.
SHOW
Analog Analog Analog
COMP
GATE/COMP GATE/COMP GATE/COMP
SENDS SENDS SENDS
MUTE MUTE MUTE MUTE
SOLO SOLO SOLO SOLO
MAIN
CHANNEL 6 CHANNEL 7 CHANNEL 8