Mitsubishi Electric Diamond View 1995SL Service Manual page 21

1995SL CRT Monitor Service Guide
Note 1
Bit Description
7 Analog / Digital Input : Defines usage of the rest if the byte as "analog input" or digital
input". Analog=0, Digital=1 . If input is described as analog, the following definitions apply to
bits 6-0.
6:5 Signal Level Standard (6:5) : Refer to the following bit definitions. Identified by the level of
reference white volts above blank, followed by the level of the sync tips in volts below
blank.
Bit 6
0
0
1
1
4 Setup: If set, the display is set to expect a blank-to-black setup or pedestal per the
appropriate signal level standard.
3:0 Sync Inputs (See Bit Operation below)
3
2
1
0
Bit 5 Operation
0 0.700V/0.300V (1.000V p-p)
1 0.714V/0.286V (1.000V p-p)
0 1.000V/0.400V (1.400V p-p)
1 0.700V/0.000V (0.700V P-P)
Separate Sync
Composite Sync (on H Sync line)
Sync on Green Video
Serration of the V.Sync Pulse is required when composite sync or sync-on-
green video is used
Chapter 1 Engineering Specification
18