Before Starting The Equipment - EINHELL GC-ET 4530 Original Operating Instructions

Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
Anl_GC_ET_4530_Set_EX_UK_SPK7.indb 12 Anl_GC_ET_4530_Set_EX_UK_SPK7.indb 12
≤ 4.1 m/s
2
h
2
- 12 -
GB

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Assembling the grass trimmer
(Fig. 3a and 3c)
•
Mount the safety guard on the motor head
(see Fig. 3a).
•
Then fix the safety guard with 2 screws (1.).
•
Finally, secure the edge guide with the last
two screws (2.) (see Fig. 3b).
5.2 Adjusting the additional handle (Fig. 4)
Place the electric grass trimmer on a fi rm surface.
Slacken the screw (Fig. 5/Item A) and move the
additional handle to its optimal position. Lock the
handle in place by tightening the screw.
5.3 Height adjustment (Fig. 4)
Place the electric grass trimmer on a fi rm surface.
First loosen the height adjuster (Fig. 4/Item 6).
Then set the required length and retighten the
height adjuster.
5.4 Adjusting the angle of the handlebar
(Figure 5)
When the lock is pressed (Fig. 5/Item 15) you can
adjust the angle of the handlebar to 5 positions.
Set the angle which is best suited for your work.
Make sure that there is an audible click when the
handlebar engages.
24.08.2023 13:28:45 24.08.2023 13:28:45