Samsung QB13R Quick Setup Manual

Quick Setup Guide
QB13R QB13R-T
* Recommended hours of use per day of this product is under 16 hours. If the product is
used for longer than 16 hours a day, the warranty may be void.
* The colour and the appearance may differ depending on the product, and the content in
the manual is subject to change without prior notice to improve the performance.
* Download the user manual from the website for further details.
http://www.samsung.com/displaysolutions
The terms HDMI and HDMI High-Definition Multimedia Interface,
and the HDMI Logo are trademarks or registered trademarks of
HDMI Licensing LLC in the United States and other countries.
Checking the Components
Contact the vendor where you purchased the product if any
components are missing.
The pictures may look different from the actual components.
Warranty card
Quick Setup Guide (Not available in Power cord
some locations)
Batteries (AAA x 2)
AC/DC adapter (Not available in Remote Control
some locations)
TOUCH OUT cable
STAND-BAR x 2
RS232C adapter
(Supported model:
QB13R-T)
-00
Troubleshooting Guide
Issues Solutions
The screen keeps Check that the cable between the product
switching on and off. and the PC is connected correctly.
Check that products (including source
device) are connected correctly with a cable.
Check that the source device connected to
No Signal is
the product is powered on.
displayed on the
screen.
Depending on the type of external device,
the screen may not display properly. In this
case, connect it with the HDMI Hot Plug
function turned On.
This message is displayed when a signal
from the graphics card exceeds the product's
maximum resolution and frequency.
Not Optimum Mode
is displayed. Refer to the Standard Signal Mode Table
and set the maximum resolution and
frequency according to the product
specifications.
The images on
the screen look Check the cable connection to the product.
distorted.
The screen appears
Check that the resolution and frequency of
unstable and shaky.
the PC and graphics card are set within a
range compatible with the product. Then,
There are shadows or
change the screen settings if required by
ghost images left on
referring to 'Preset Timing Modes' .
the screen.
Using the STAND-BAR
Place the product with the face down on top of the protective cloth or cushion.
Insert the bar into a slot on the product and then turn to fasten.
Parts
Remote sensor
1
Press a button on the remote control pointing at the sensor on the front of the product to perform the corresponding function.
* Using other display devices in the same space as the remote control of this product can cause the other display devices to be
inadvertently controlled.
Power button
2
Turns the product on or off.
Administrator menu (Supported model: QB13R-T)
* Touching and holding on the screen when the product is turned on displays the administrator menu.
* If the touchscreen control is not available, use the remote control to go to System → Touch Control → Touch Control and select On from
the OSD menu. And go to Device to Control and select Samsung SMART Signage or Auto.
* If the administrator menu is not displayed, use the remote control to go to System → Touch Control → Admin Menu Lock and select Off
from the OSD menu.
Speaker