Removal; Transporting; Protection Against Frost (Emptying The Appliance) - Bosch SM Series Instruction Manual

Use only a residual current operated
■
circuit-breaker which features the
symbol ‚. Only this extension
guarantees compliance with
the currently valid regulations.
The appliance features a water
■
damage protection system. Please
note the system will function only
when the power supply
is connected.

Removal

Also observe
the sequence of worksteps here.
Disconnect the appliance from the
1.
power supply.
Turn off the tap.
2.
Undo the waste water and drinking
3.
water connection.
Loosen fastening screws for the
4.
furniture parts.
If fitted, remove the base panel.
5.
Pull out the appliance, carefully
6.
pulling the hose behind.

Transporting

Empty the dishwasher and secure loose
parts.
Drain the appliance according
to the following steps:
Turn on the tap.
1.
Open the door.
2.
Switch on ON/OFF switch (.
3.
Select programme with the highest
4.
temperature.
The estimated programme duration
is indicated on the display window at
the top @.
Press START button )*.
5.
Close the door.
6.
Programme sequence starts.
Open the door after
7.
approx. 4 minutes.
Press START button )* until
8.
"Program was terminated"/"Ready in
one minute." is indicated at the top
of the display window @.
Installation and connection en
Close the door.
9.
Open the door after approx. 1
10.
minute.
The display window at the top @
indicates; "Finished".
Switch off ON/OFF switch (.
11.
Turn off the tap, disconnect supply
12.
hose and drain water.
Transport appliance upright only.
Note:
This prevents residual water from
running into the machine control
and damaging the programme
sequence.
Protection against frost
If the appliance is in a room where there
n g t h e a p p l i a n c e ) s t f r o s t ( E m p t y i P r o t e c t i o n a g a i n
is a risk of frost (e.g. holiday home),
empty the appliance completely (see
Transportation).
53