en Installation and connection
Electrical connection
Connect the appliance only to 110 V
■
and 60 Hz alternating current via
a correctly installed socket with
protective conductor. See rating
plate for required fusing 9:.
The socket must be near
■
the appliance and freely accessible
following installation.
If the plug is not freely accessible,
an allpole disconnector with
a contact opening of at least 3 mm
must be fitted on the installation side
to satisfy the relevant safety
instructions.
The connection may be modified by
■
technicians only.
A power cord extension may be
■
purchased from customer service
only.
The appliance features a water
■
damage protection system. Please
note the system will not function
unless the power supply
is connected.
48
Removal
Also observe
the sequence of worksteps here.
Disconnect the appliance from the
1.
power supply.
Turn off the tap.
2.
Undo the waste water and drinking
3.
water connection.
Loosen fastening screws for the
4.
furniture parts.
If fitted, remove the base panel.
5.
Pull out the appliance, carefully
6.
pulling the hose behind.