Table of Contents
Advertisement
15Min Auto Off
• When 15Min Auto Off is set to On, TV will turn off if there is no signal in 15Min.
Auto Sensing
• The input is automatically switched when the input signal that you set to On is received.
• If Auto Sensing is set to Off, the input is not switched when the input signal is received.
• If SIMPLINK is set to On, HDMI is automatically set to Off and can not work.
• If the signal is removed while Auto Sensing (automatic input switch) is enabled, the input returns to the previous setting.
• If the several inputs are connected by enabling Auto Sensing and the automatic input switch is performed several times, the input returns to the
previous setting only for the last input and does not repeat the operation for the rest.
• For the AV input connected using the euro scart cable, Auto Sensing does not work for the TV input because the Auto AV function is enabled.(For
other inputs, Auto Sensing works normally.)
Forced DVI Audio
• When Forced DVI Audio is selected, the audio signal from the HDMI port will be transmitted through the RGB, AV, or Audio In #1 component ports.
• The video signal will be transmitted through HDMI to be displayed on the screen in standard quality.
WOL(Wake On Lan)
(Depending on model)
• If Set to On, User can turn on the TV by using LAN network.
DPM
• You can configure the DPM (Display Power Management) function.
• If this option is not set to Off, the TV set enters DPM mode when there is no input signal. DPM can be set to Off / 5 sec / 10 sec / 15 sec / 1 min / 3
min / 5 min / 10 min.
• If you set this option to Off, the DPM function is disabled.
NOTE
• Instant on supported models:
• If Instant on of Configuration Setup is enable (Reset mode or Mute Mode), USB Auto Playback can't be used.
21
Advertisement
Table of Contents
