LG 32LT340CBDB Installation Manual page 42

42
(g)( )([Set ID])( )(OK/NG)([Data])(x)
7 [Brightness] (Command: k h)
►To adjust screen brightness.
You can also adjust brightness in the picture settings.
Transmission
(k)(h)( )([Set ID])( )([Data])(Cr)
Data Min : 00 to Max : 64
* Refer to "Real data mapping".
Ack
(h)( )([Set ID])( )(OK/NG)([Data])(x)
8 [Colour] (Command: k i)
►To adjust the screen colour.
You can also adjust colour in the picture settings.
Transmission
(k)(i)( )([Set ID])( )([Data])(Cr)
[Data] Min : 00 to Max : 64
* Refer to "Real data mapping".
Ack
(i)( )([Set ID])( )(OK/NG)([Data])(x)
9 [Tint] (Command: k j)
►To adjust the screen tint.
You can also adjust tint in the picture settings.
Transmission
(k)(j)( )([Set ID])( )([Data])(Cr)
[Data] Red : 00 to Green : 64
* Refer to "Real data mapping".
Ack
(j)( )([Set ID])( )(OK/NG)([Data])(x)
10 [Sharpness] (Command: k k)
►To adjust the screen sharpness.
You can also adjust sharpness in the picture settings.
Transmission
(k)(k)( )([Set ID])( )([Data])(Cr)
[Data] Min : 00 to Max : 32
* Refer to "Real data mapping".
Ack
(k)( )([Set ID])( )(OK/NG)([Data])(x)
11 OSD Select (Command: k l)
►To select OSD (On Screen Display) on/off when controlling remotely.
Transmission
(k)(l)( )([Set ID])( )([Data])(Cr)
[Data] 00 : [Off]
[Data] 01 : [On]
Ack
(l)( )([Set ID])( )(OK/NG)([Data])(x)
12 Remote Control Lock Mode (Command: k m)
►To lock the front panel controls on the monitor and remote control.
Transmission
(k)(m)( )([Set ID])( )([Data])(Cr)
[Data] 00 : [Off]
[Data] 01 : [On]
Ack
(m)( )([Set ID])( )(OK/NG)([Data])(x)
* If you are not using the remote control, use this mode. When main
power is on/off, external control lock is released.
* In the standby mode, if key lock is on, TV will not turn on by power on
key of IR & Local Key.
13 [Balance] (Command: k t)
►To adjust balance.
You can also adjust balance in the audio settings.
Transmission
(k)(t)( )([Set ID])( )([Data])(Cr)
[Data] L : 00 to R : 64
* Refer to "Real data mapping".
Ack
(t)( )([Set ID])( )(OK/NG)([Data])(x)
14 [Colour Temperature] (Command: x u)
►To adjust Colour Temperature. You can also adjust Colour
Temperature in the picture settings.
Transmission
(x)(u)( )([Set ID])( )([Data])(Cr)
[Data] Warm: 00 to Cool:64
* Refer to "Real data mapping".
Ack
(u)( )([Set ID])( )(OK/NG)([Data])(x)