Hornady SnapSafe 75530 Owner's Manual

OPEN GUN VAULT BY COMBINATION CODE
Enter the previously programmed 4 to 6 digit code to open the safe.
Note:
• Pressing a button should illuminate the keypad green.
• When a correct code is entered, the keypad will turn green and the door
should open.
• If an incorrect code is entered, the red light will blink and beep twice.
• After five incorrect entries, the red light will blink and beep during the 2
minute lockout. The safe can only be opened by the mechanical key during
this time.
• The first button pressed will both wake the safe up and register as the first
entered number in the code.
LOW BATTERY WARNING
To check the battery level, press any button to illuminate the keypad.
If the battery level is lower than 25%, the keypad will illuminate yellow.
The batteries should be replaced immediately to ensure proper function.
KEYPAD TONES ON/OFF
Press and hold the "1" button for
three seconds to toggle sound ON
and OFF .
Note: Toggling the sound off will
turn the keypad, program, and
alarm beeps off. Toggling the sound
on will turn the keypad, program,
and alarm beeps on.
Item No.: 75530
Ext. Dimensions: 12.7" x 9.0" x 8.8"
Weight: 12.8 Lbs
Power: 4 AAA batteries (not included)
Customer Service: PO Box 1848, Grand Island, NE 68802-1848
1-877-214-4470 | Email: info@snapsafe.com
12/2019
Owner's Manual
Two-Gun Biometric Vault
18SNAP0029
Item No. 75530