Ariens Zoom 34 Owner's/Operator's Manual page 28

4. Charge battery according to battery
charger and battery manufacturers'
instructions.
5. Install battery on unit. See Factory-
Installed Battery Removal and
Installation on page 26.
Jump-Starting
Ariens does not recommend jump-starting
your unit. Jump-starting can damage engine
and electrical system components. See your
engine manual for more detailed information.
CARBON CANISTER FILTER
(If Equipped) (Figure 21)
1
1. Carbon Canister
2. Carbon Canister Filter
Figure 21
Clean or replace the carbon canister filter
whenever the engine air filter is cleaned or
replaced.
ADJUSTING STEERING LEVERS
(Figure 22)
Adjustment 1
2
1. Handlebar
2. Upper Control Arm
3. Adjustment Holes
4. Eccentric Spacer
5. Mounting Hardware
6. Lower Control Arm
IMPORTANT: Adjust each steering lever
equally.
NOTE: When adjusting steering levers for the
first time it is recommended that you make
adjustments in the following order.
1. Adjust Steering Lever Height
1. Remove mounting hardware that
attaches the handlebars to the upper
control arm. Move handlebar up or down
until the handlebar mounting holes are
aligned with the preferred adjustment
holes.
2. Install mounting hardware and tighten.
2. Adjust Steering Lever Width
1. Loosen hardware at the base of the
lower control arm (item 5).
2. Rotate eccentric spacer to move the
levers away from or closer to the
operators position (figure 23).
3. Tighten hardware.
EN - 28
Adjustment 3
3
2
6
Adjustment 2
Figure 22
1
5
4