Sub-Zero 427R Planning Information page 7

Planning Information
Wine Storage Model 427R
IMPORTANT NOTE: Wine Storage
models with a solid door are available
as a special order and require 90 days
for delivery.
A solid panel must not be
installed on a glass door unit, as
this may cause moisture to form
behind the panel.
Dimensions in parentheses are in
millimeters unless otherwise specified.
I N T E G R A T E D P A N E L S
The dimensions of these panels and stiles are assuming
the Model 427R finishes off at 80" (2032) in height overall
and has a 4" (102) toe kick. If you finish off at 84" (2134)
for instance, you must add 4" (102) additional to the
overall height of the panel and remember to add 4" (102)
to the top rail. Likewise, if you allow for a 6" (152) toe kick
for the Model 427R, you must subtract 2" (51) from the
bottom rail.
IMPORTANT NOTE: The toe kick area on the Model 427R
cannot be larger than 9" (229) or less than 4" (102).
The door panel for Model 427R can grow beyond the 80"
(2032) height to accommodate any size of door as long as
you stay below door panel weight limit of 40 lbs (18 kg)
for solid door and 20 lbs (9 kg) for glass door units. Refer
to the upper valance specifications for Integrated Models.
IMPORTANT NOTE: If you are installing Sub-Zero's
optional lock kit on a Model 427R, you may have to order
a door panel that exceeds the 80" (2032) finishing height.
Consult the lock installation instructions and see if your
panels will allow for an adequate installation.
The door frame of the unit has pre-drilled holes for our
optional handle hardware. Refer to Hardware Considera-
tions on page 12 for specifics about installing handle
hardware on this overlay application.
Refer to the charts and illustrations on the following pages
for specific dimensions for integrating cabinetry for Model
427R.
For additional specifications and installation information
specific to Model 427R, refer to pages 2–5. Also refer to
the comprehensive installation instructions that are
shipped with each unit.
7