Sub-Zero 427R Planning Information page 6

Planning Information
Wine Storage Model 427R
A solid panel must not be
installed on a glass door unit, as
this may cause moisture to form
behind the panel.
Dimensions in parentheses are in
millimeters unless otherwise specified.
I N T E G R A T I N G C A B I N E T R Y
Unless you are installing a stainless steel unit, you will
need to provide a full door panel in the instance of a solid
door unit, or a frame for the glass door application, where
wine will be seen from the outside. You will also have to
provide drawer front panels. If you order a stainless steel
Model 427R, you will need to have the stainless steel
panels and handles installed.
I N T E G R A T E D P A N E L S
If you are familiar with our Integrated line and its panel
applications, this section will be relatively easy to under-
stand. The Wine Storage solid door panels or frame panels
for glass doors will follow some of the identical planning
processes you learned with the Integrated line. The instal-
lation of the door panels is completely different, however.
Rather than using the mounting hardware we used with
the Integrated units, the door panel for Model 427R will be
attached with screws applied through our door.
The drawer panels for the Model 427R will be applied
using the Integrated technique of mounting brackets.
IMPORTANT NOTE: The depth of Model 427R is 24"
(610) from the front of the unit to its back. You MUST
allow for the thickness of the panel you are applying
when planning for the finished rough opening depth if
you want the front panel to be flush with surrounding
cabinetry. You may have to move the unit back into
drywall or bring the cabinets forward.
The glass door opening of the standard Model 427R is
designed to be exposed to room air circulation. Decorative
overlays on the glass should be kept to a minimum. While
the cabinet front stiles are a minimum of 2
top and bottom rails are different. Rails and stiles can be
increased in size but should not exceed cabinet manufac-
turers standard width. They cannot exceed overall door
panel dimensions specified, as they would interfere with
the operation of the door. The back sides of rails and stiles
that will be visible through the glass door will need to be
finished. Also, the inside edges of the frame must be
finished to match the front surface.
1
/ " (57), the
4
6