Integrated Refrigeration - Sub-Zero 424FS Design Manual

I N T E G R A T E D R E F R I G E R A T I O N
C A B I N E T R Y A P P L I C A T I O N S
Integrated refrigeration is compatible with virtu-
ally any style and look of cabinetry. The models
can be used with framed as well as frameless
cabinets. Because of the precise application and
the look you may want to achieve, there are
important questions you need to answer before
ordering panels for the doors/drawers. As you
look at styles of cabinets, keep some important
facts in mind:
P A N E L
IMPORTANT NOTE: The depth of each Inte-
R E Q U I R E M E N T S
grated model is 24" (610) from the front of the
unit to its back. You must allow for the thick-
Door and drawer
panels must be a
ness of the panel you are applying when
minimum of 5 / " (16)
8
planning for the finished rough opening depth if
thick.
you want the front panel to be flush with
The door panel
surrounding cabinetry. You must move the unit
cannot exceed 40 lbs
back into drywall or bring the cabinets forward
(18 kg) and each
to achieve a flush fit.
drawer panel must
not exceed 12 lbs
The height of the door panel can grow beyond
(5 kg) for 27" (686)
3
45 /
wide units. For 36"
(914) wide units, the height as long as you stay below the recom-
door panel weight
mended door panel weight limit.
limit is 53 lbs (24 kg)
and 16 lbs (7 kg) for
The toe kick clearance can vary with the height
each drawer panel.
of the lower drawer panel; the maximum panel
height is 16
minimum space of 4" (102) clear below the
bottom edge of the lower drawer panel so the
unit can be properly vented.
We recommend using D-style handles. For the
cabinet door, handles must be located near the
edge of the panel opposite the hinge, centered
top to bottom. Locate handles in the top center
area of the drawer panels.
IMPORTANT NOTE: The inside edges of the
rough opening, as well as the sides and a
portion of the backside of the decorative panels
will need to be finished, as they will be exposed
when the doors are open.
SUB-ZERO
UNIT
CABINET
FRAME
CABINET DOOR PANEL
1 /8" (10)
DOOR
REVEAL
27
OR
(686)
Traditional frame – full overlay
(top view)
40
" (1153) and exceed the 80" (2032) overall
8
11
/ " (424). You must keep a
16
24
(610)
TO WALL
CABINET
FRAME
CABINET
DOOR
36
(914)
Traditional frame – standard overlay
(top view)
F R A M E D C A B I N E T R Y
Framed cabinetry applications present you with
different questions to address. The illustrations
below show common applications of framed
cabinetry. These are not meant to be the only
alternatives, but are suggestions from designers
around the country. Also refer to the full-scale
illustrations at the end of this section for
specifics on door openings.
NOTE: In the illustrations below, the first width
dimension shown is for 27" (686) wide units
and the second dimension is for 36" (914) wide
units.
24
SUB-ZERO
(610)
UNIT
TO WALL
DOOR PANEL
1 /8" (10)
REVEAL
27 36
OR
(686) (914)
Traditional frame –
(top view)
SUB-ZERO
UNIT TO WALL
CABINET
FRAME
CABINET
DOOR PANEL
1 /8" (10)
DOOR
REVEAL
27 36
OR
(686) (914)
3
/ " (10) offset
8
24
(610)