Panasonic Digital Palmcorder Multicam PV-DV92 Operating Instructions Manual page 13

Supplying Power
Charge the Battery Pack on
the AC Adaptor
D 1 Connect and plug in the Power Cord
a as shown.
+ POWER Lamp will light.
+ Remove the DC Cable, if attached,
from the adaptor.
UJ
4»)
he
(e)
-
49)
G
wn
M
Attach the Battery as shown to
charge.
e CHARGE Lamp lights up. It goes out
when charging is complete (approx.
1 hour). Expect approx. 1 hour
30 minutes of operation (EVF usage)
when fully charged.
Remove the Battery.
Slide the Battery out and then lift up.
About the Flashing of the CHARGE Lamp
+ Charge the Battery within an ambient temperature range of 10 °C (50 °F) and
30 °C (86 °F).
* If charging is done in extreme low or high temperatures, Battery charge time increases.
CHARGE Lamp flashes when...
» The Battery is being charged, but charging is taking longer than normal.
* Charging is not possible. Remove the Battery once, wait a short time, then re-attach it
for charging.
Insert the Battery Pack Remove the Battery Pack
BATT RELEASE
2 Remove the Battery Pack and slide
the Battery downward while sliding the
BATT RELEASE.
13