Table of Contents
Advertisement
ASSEMBLING HEAD RAISING AND
LOWERING HANDLE
Using a screw driver (A), assemble the head raising and lower¬
ing handle (B) to the handle bracket (C) as shown in Fig. 9.
ASSEMBLING SWITCH TO THREE
PHASE MACHINE
If you purchased the three phase machine, it is necessary
to assemble the switch and switch plate assembly (A) to the
front left hand side of the planer, as shown in Fig. 10, using
the two screws (B),
ASSEMBLING BELT GUARD,
MOTOR PLATE, MOTOR PULLEY,
MOTOR AND BELTS
TO SINGLE PHASE MACHINE.
1,
Remove cover from side of belt guard and assemble
belt guard (A) to the side of the planer using screw and washer
(B) and long screw (C) and spacer (D), as shown in Fig. 11.
The belt guard (A) should be as far to the left as it will travel
in slot (E) as shown in Fig. 11, for correct operating position.
5
Fig. 11
Advertisement
Table of Contents
