Specifications - Sony TA-V7700 Operating Instructions Manual

MicolUie)(=\-yatereiiatemerulre(=
Before going through the check list below, first refer back to the connection and operating procedures.
Should any problem persist after you have made these checks, consult your nearest Sony dealer.
Trouble
Cause
_
No audio
No audio from one
channel or unbalanced left
and right sound level.
| No recording
position
| Lack of bass sound or
obscure instrument
© Faulty setting of INPUT SELECTOR.
¢ Faulty connection
«The ADAPTOR switch is set to ON when
the ADAPTOR jacks are not used.
¢ The equipment connected to the
ADAPTOR jacks is not turned on.
—
¢ Set it correctly.
¢ Connect the unit and other equipments
correctly.
¢ Turn OFF the ADAPTOR switch.
=
Remedy
¢ Set the ADAPTOR switch to ON or turn on the
equipment.
Incorrect setting of the BALANCE control.
Set the BALANCE correctly.
Severe hum or noise
The REC OUT SELECTOR is not correctly | Set the selector correctly.
set.
Mal-setting of sound quality controls
e Noise from TV, etc.
¢ Faulty connection of turntable system © Connect correctly.
Ground the turntable system.
Adjust the controls for sound quality.
¢ Keep the connecting cords away from
transformers or motors, TV and fluorescent
lights.
Specifications
Continuous RMS power (both channels driven)
Music power output
80 W + 80 W (6 ohms) at 1 kHz
70 W + 70 W 6 ohms) at 40 Hz — 20 kHz
300 W
Harmonic distortion Less than 0.02% at rated output
1M distortion (60 Hz: 7 KHz = 4: 1)
Less than 0.02% at rated output
Frequency response
PHONO: RIAA equalization curve
+0.5 dB
TUNER |
TAPE 1, 2 7 +0
VIDEOICD | 10 Hz - 50 kHz_-5dB
ADAPTOR
Residual noise Less than 130 pV (6 ohms network A)
Input
joey S/N (network,
| Input | Sensitivity Impedance input level)
| PHONO 2.0 mV 50 kohms 70 dB {A, 2.0 mV)
TUNER
TAPE 1,2 91 dB
y V
vipeocp. =| O™ SOkohms | (a, 150 mV)
ADAPTOR Tens
DA converter
Frequency 4Hz-20kHz2+3.dB
SIN More than 95 dB
Outputs
Output Type Voltage Impedance
DAT OUT
ADAPTOR
TAPE 1,2 Phono 150 mV 1kohms
VIDEO
HEAD- Stereo Accepts headphones of 8 ohms
PHONES phone or more.
a |
Tone controls
BASS +10 dB (at 100 Hz)
TREBLE +10 dB (at 10 kHz)
BASS BOOST +10 dB (at 20 Hz, 1W)
General
Power requirements
Model for continental European countries:
220 V AC, 50/60 Hz
Model for United Kingdom: 240 V AC, 50/60 Hz
Power consumption
Model for continental European countries: 150 W
Model for United Kingdom: 350 W
AC outlet 1 Unswitched, 200 W max.
Dimensions Approx. 355 x 130 x 368 mm (w/h/d)
Weight Approx. 10.2 kg (22 ib 8 02), net
Design and specifications subject to change without notice.
13