Conversion To Other Types Of Gas - Zanussi GC 20 M Instructions For The Use And Care

the electricity supply network (mains) has
an efficient earth connection according to
the established rules and existing
regulations;
with the cooker definitely installed, the
wall socket or the omnipole switch can
easily be reached.
The Manufacturer disclaims any liability
in case these accident-preventing rules
are not observed.
The heat insulation of the oven and grease
residues from the manufacturing process
produce smoke and an unpleasant smell
during the first minutes of operation.
It is therefore advisable, the first time
the appliance is used, to pre-heat the oven
for about 30 mins. at peak temperature
without putting any food into it.
Conversion to
other types of gas
Attention: The cooker is adjusted for
NATURAL GAS (METHANE).
To adapt the cooker to a type of gas
different from the one for which it is
adjusted, perform the following
operations in the order.
Replacing the nozzles (see chart)
Remove the pot-rests and the burners;
undo the screws securing the worktop,
lift it up (to keep it raised, use the
special supporting rod located on the
mounting of the left-hand burners),
unscrew the nozzles and replace them
with the corresponding nozzles (supplied
with the cooker) suitable for the new type
of gas.
Refit the parts reversing the above
procedure.
15