Zanussi GC 20 M Instructions For The Use And Care page 13

Fig. 13
Position the appliance.
The appliance incorporates a set of
adjustable feet.
By properly adjusting the feet, the
appliance can be set up at the required
height and correctly aligned with the
kitchen furniture or any other surface,
thus ensuring an even spreading out of
liquids in pans and pots.
These adjustable feet are easily accessible
after removing the dish-warming drawer.
To remove this drawer, proceed as follows:
pull out the drawer to the limit stop in
order to slide out completely the side
runners;
shift the front rollers up to the
"buttonholes" of the side runners;
lift up the drawer and slide out the front
rollers;
pull out the drawer and shift the rear rollers
up to the "buttonholes" of the side runners;
lift up the drawer and slide out the rear
rollers;
To replace the drawer, reverse the above
procedure.
Alignment of the worktop
To allow the alignment with the kitchen
unit, the worktop frames are removable:
Remove the two screws (A - Fig. 11) fixing
the gasket (E - Fig. 11) placed on the back
of the worktop and then slide out the
gasket;
Remove the two cover shock absorbers
(B - Fig. 12);
Loosen the four screws (C - Fig. 12) fixing
the side frames (D - Fig. 12) to the
worktop;
Slide forward the two side frames
(D - Fig. 12);
Block the side frames (D - Fig. 12) by means
of the four screws (C - Fig. 12) to the
worktop;
Refit the cover shock absorbers (B - Fig. 12);
Fit the gasket (E - Fig. 13) on the front
side of the worktop and fix it by means
of the two screws (A - Fig. 13).
13