Conversion From Natural Gas To Lpg - Zanussi ZCM 620 X Instruction Booklet

Conversion from Natural to LPG Gas
It is important to note that this model is designed for
use with natural gas but can be converted for use with
butane or propane gas providing the correct injectors
are fitted. The gas rate is adjusted to suit.
Method
• Ensure that the gas taps are in the 'OFF' position
• Isolate the hob from the electricity supply
• Remove all pan supports, burner caps, rings, crowns
and control knobs.
• With the aid of a 7mm box spanner the burner
injectors can then be unscrewed and replaced by the
appropriate LPG Gas injectors (see table: page 24).
TO ADJUST THE GAS RATE
With the aid of a thin bladed screwdriver completely
tighten down the by pass adjustment screw, which is
located down the centre of the gas tap control shaft.
Upon completion stick the replacement rating plate
near the gas supply pipe.
IMPORTANT
The replacement/conversion of the gas hob should
only be undertaken by a CORGI registered engineer.
30