Installation; Uhf Tuning - Pace MSS100 Series Service Manual

Installation
UHF TUNING
Note
You can ignore this section if the satellite receiver
and TV (and video recorder) are connected by SCART
leads.
If the satellite receiver is connected to the TV (and video
recorder) by coaxial leads then you must perform UHF
tuning.
Notes
You may connect the satellite receiver by both SCART
and coaxial leads. As long as SCART leads have been
used to connect your satellite receiver, TV and video
recorder you do not need to perform UHF tuning.
It is important that the UHF channel chosen for
satellite TV is not used for the video recorder and is
free of any other broadcasting.
Tuning the TV (and video recorder) to the
satellite receiver
The satellite receiver has been factory set to UHF chan-
nel 38 (UHF frequency 607.25 MHz). To tune the TV to
this channel proceed as follows:
»> Press the number key(s) on the TV handset that you
want to use for satellite TV.
>> On the satellite receiver handset press F, 5.
The red light on the front panel of the satellite receiver
should flash.
tf the TV channel chosen corresponds to UHF channel 38
then you will see the satellite receiver UHF Tuning Menu
onscreen. if you do not see this menu then you must
tune the TV in accordance with the manufacturer's
instructions until a good quality picture of the UHF
Tuning Menu is visible.
>> Press NORM to renove the UHF Tuning Menu from
the screen.
>> You should now see a satellite TV programme.
>> Set your video recorder to the same UHF channel.
Tuning your satellite receiver to a UHF
channel
>> Select the number key(s) on your handset that you
want to use for satellite TV.
>> Set the UHF channel for this handset key to one that
is free of any other broadcasts, for example UHF
channel 46.
>> Press F, 5 on the satellite receiver handset.
The receiver's UHF Tuning Menu is now selected
(although you cannot see it yet). The red light on the
front panel should flash.
>> Press the two number keys on the satellite receiver
handset that correspond to the chosen UHF channel
number, in this example 4, 6.
You should see the UHF Tuning Menu on the TV screen.
>> Press STORE to save this setting.
>» Set the video recorder to the same UHF channel.
Note
If having completed the tuning, you see a UHF
Tuning Menu but no picture, check the Band
setting at the Set Up Programme Menu.
UHF Tuning
Channel
Fine Tune
Fine tuning
To get the sharpest picture, you may wish to fire tune at
the UHF Tuning Menu.
>> Press & or ¥ to select the Fine Tune option.
>) Press < or » to get the sharpest picture.
>> Press STORE.
You can fine tune between -3 and +4. If you prss > at
+4, the channel increases by one and Fine Tune
becomes -3.
MSS 100 Series Satelit: Receiver
ENGLISH