Schlage L9000 Series Installation Instructions Manual page 9

1
Install outside indicator assembly.
1a Rotate the indicator module spindle until the sign moves
down and uncovers the arrow markings.
Do not use tools on spindle!
Front
1b Place the indicator module against the door.
1c Install alignment cylinder with cylinder spring. Use any
slotted screwdriver, lever wrench, or coin to rotate the
cylinder.
L Make sure tabs are flush with chassis.
L NOTE: Rotate until the cylinder is flush with surface.
Use a level or the armor plate to ensure the cylinder face is
flush to the shaded areas as shown.
L NOTE: Slot in the alignment cylinder must be vertical
after installing the alignment cylinder.
Privacy indicator
Back
Slot in alignment
cylinder must be
vertical.
L Note: Alignment
cylinder face
needs to be flush
with indicator
module.
1d Install mounting screw with flange.
Before fully tightening the screw, use a level to align the
module assembly so that it is parallel with the door edge.
DO NOT drill the door hole through the module
opening!
1e Install outside indicator escutcheon assembly
1f Proceed with the appropriate steps to install trim on
opposite side. If both trims are installed, proceed to page
11 to complete installation.
1
Install the escutcheon assembly.
1a
1b Proceed with the appropriate steps to install trim on
opposite side. If both trims are installed, proceed to page
11 to complete installation.
L Note: If not pre-drilled, mark
the top hole of indicator
module, remove module,
and drill a ⁵/32" hole. Follow
steps 1a to 1c to reinstall.
Coin turn
9