Schlage L9000 Series Installation Instructions Manual page 4

1
Install outside indicator trim.
1a Rotate the indicator module spindle until the sign moves
down and uncovers the arrow markings.
Do not use tools on spindle!
Front
1b Place the indicator module against the door.
1c Insert key halfway into the cylinder, and install the
cylinder with cylinder spring as shown.
4
Outside cylinder indicator
Back
2
Install mounting screw with flange.
Before fully tightening the screw, use a level to align the
module assembly so that it is parallel with the door edge.
DO NOT drill the door hole through the module
opening!
L Make sure tabs are flush with chassis.
2a Remove cylinder.
2b Mount the escutcheon.
Make sure tabs are
flush with chassis.
L Note: If not pre-drilled,
mark the top hole
of indicator module,
remove module, and
drill a ⁵/32" hole. Follow
steps 1a to 1c to
reinstall.