Advertisement
Available languages
Available languages
WHAT'S WHERE ?
FRONT PANEL - fig. 1, page 3
G) ON/OFF button - press in to switch the unit on; press
again to switch off
@) display showing:
LW (Long Wave), MW (Medium Wave) or FM - the select-
ed waveband
AUTOSCAN - automatic tuning mode
AUTOSCAN HIGH - automatic tuning at increased sen-
sitivity
TUNED - when a station is found and correctly tuned to
STEREO or MONO - FM stereo or mono reception
STORE - when the memory has been opened to store a
preferred station
The
tuned frequency in 'MHz' (for FM) or 'kKHz' (for MW
and LW)
1 to 59 - the number of the selected preset station
The name of the station. If you have tuned to a transmit-
ter with RDS signal, the name given by the station will
aopear automatically. For the other transmitters you can
program a name yourself.
DISTANT or LOCAL - the selected aerial
MUTING - during silent tuning
TIMER - the timer program is activated
r-—
- the bandwidth
1) to 7) - the signal strength
DIMMER - you can now adjust the display brightness
@) waveband buttons - to select LW, MW or FM band
G@) AUTO/MAN button - to select automatic or manual
tuning and to adjust the display brightness
@ TIMER button - to program 3 stations for use with an
external timer
(6) TUNER 4 Y buttons - press 4 to tune towards the
higher end of the selected band and press ¥V to tune
towards the lower end of the selected band
@) PRESET SCAN/CURSOR 4
buttons - to call up pre-
set stations in ascending 4 or descending order V and
to move the cursor when programming a name
SCAN.SENS button - to select a higher tuning sen-
sitivity when tuning automatically to FM transmitters
@) WIDTH button - to select the bandwidth (wide or nar-
row) for FM stations
LOC/DIST button - to select the aerial connected to the
socket LOCAL or to the socket DISTANT
@) MUTE button - for silent tuning
@2) MONO button - for mono reception
@ F/P button - to enter directly the tuning frequency
STORE button - for opening the memory to store a pre-
ferred station and to enter a name into the memory
@) figure/alphabet buttons:
figures -0 to 9
letters - A to Z
symbois -/, +, <,-, >, #
space - u4
CHAR. button - for opening the memory to program a
name
@) "F- - to switch between 1- and 2-digit number entry
RDS DISPLAY button - to select between the name and
the frequency of a station
RDS AF button - to display the alternative frequencies
of the tuned station
BACK PANEL - fig. 2, page 3
@o) FM-ANTENNA DISTANT - socket for connection of:
— a roof-mounted FM aerial with an impedance of
75 ohms
— the supplied wire aerial (to the centre pin)
@i) FM-ANTENNA LOCAL - socket for connection of:
— the Community or Cable Antenna System, impedance
75 ohms
@) LOOP ANTENNA - terminals for connection of:
— the MW/LW loop aerial
— an external AM aerial, Y for the aerial wire and + for
the ground wire
@3) AF/NF OUTPUT - output sockets for connecting the
tuner to an amplifier
@4) REMOTE CONTROL - RC-5 remote control input/output
sockets
@5) loop aerial - for MW/LW reception
@s) mains lead
The type plate is located on the back of the set
This product complies with the radio interference require-
ments of the European Community.
Advertisement
