Dynex DX-32L200A12 Service Manual page 12

3.4 HDMI port
Input HDMI signal from signal generator VG849 with the formats as Table 6, check if the
display and the sound are normal.
4 User menu preset before leaving factory
Enter into factory menu, select Other Setting→ SHIPMENT, the TV set will perform preset
automatically, and the step must be done after the factory alignments have been completed,
main operations of SHIPMENT are described as below:
a) Clear out all programs information;
b) Clear V-CHIP information;
c) Analog value default setting for all sources;
d) Power on mode set to off;
e) Active Setup Wizard menu
Note: After user menu preset has been completed, it is necessary to exit menu, turn off the
TV set to standby mode, then cut off the power supply.
5 Instruction of factory software burning is shown as Table 7
Location
Part No.
No.
NS04 5272532005
Note : Write-protection setup method
Enter into interface AUTO of burning program ALL-100, mark item "Config" which must
be selected during burning process. Click item "Config Setting", set item "Protect" as
"All Protect", "SRWD" as "Enable", and write-protection must be re-set after burning
program ALL-100 startup every time.
6 Software upgrade from U disk
Software can be upgraded from U disk after the TV set is leaving factory, please refer to
options below for details:
Aligment Instructions
Table 7 Instruction of factory software burning
Part type
MX25L3205DM2C-12G
Software
Burning method
function
use tool like
Main write-protection
program please refer to Note below for
details
remark
ALL11 ect.,
is needed,
For all models