Yamaha GRIZZLY 550 2013 Owner's Manual page 25

after the engine is started, the EPS system may
not be working correctly. When this occurs, have a
Yamaha dealer check the EPS system.
The electrical circuit of the warning light can be
checked by turning the key to "
warning light does not come on, have a Yamaha
dealer check the electrical circuit.
TIP
●
If the engine is stopped using the engine stop
switch and the key is in the "
the EPS warning light comes on to indicate that
the power assistance for the steering is not func-
tioning.
● If the steering load is too heavy (i.e., excessive
steering use when the ATV is traveling at a slow
speed), the power assist is reduced to protect
the EPS motor from overheating.
EBU30450
On-Command four-wheel-drive indicator "
On-Command differential gear lock
indicator " " and indicator light "DIFF.
LOCK"
The On-Command four-wheel-drive indicator "
comes on when the On-Command four-wheel-
drive switch is set to the "4WD" position.
The
indicator "
gear lock indicator light "DIFF. LOCK" come on
when the On-Command differential gear lock
" (on). If the switch is set to the "LOCK" position.
TIP
●
●
" (on) position,
",
"
4-4
On-Command differential
" and the On-Command differential
Due to the synchronizing mechanism in the dif-
ferential gear case, the four-wheel-drive indica-
tor may not come on until the ATV starts moving.
When the On-Command differential gear lock
switch is set to "LOCK" or "4WD", the
indicator " " and the indicator light "DIFF.
LOCK" will flash until the differential gear is com-
pletely locked or unlocked. If the indicator and
the indicator light continue to flash, the differen-
tial is not completely locked or unlocked. In this
case, start moving to allow time for the differen-
tial to lock or unlock.
gear lock
4