Advertisement
USER GUIDE
E11 - E13 Do not apply to this model.
P1: Pump Circuit open (Only if unit has drain pump.)
15: CLEAR ERROR LOG
To clear errors, press and hold
CLR is flashing.
16: THERMISTOR - 1 DIFFERENTIAL
This number should not be adjusted.
17. Does not apply to this model.
18. THIS NUMBER SHOULD NOT BE ADJUSTED
19. THIS NUMBER SHOULD NOT BE ADJUSTED
20. INDIVIDUAL COMPONENT TOGGLE
SEE RELAY / OUTPUT CHART
21. MODEL NUMBER INDICATOR
Displays the two-digit model number of the specific
unit. See Model list table.
22. LIGHT ALL LED SEGMENTS
This will illuminate all the LEDs on the display to
ensure they work properly
23. ACTIVATE DEFROST /HARVEST
-Press and hold for 3 seconds to activate
24. FACTORY DEFAULTS
-Press and hold for 3 seconds to restore all values to
factory defaults
MAIN SOFTWARE
25.
26. Does not apply to this model
27. FACTORY TEST MODEL - DO NOT USE
28. COMPRESSOR RPM
29. - 32. Do not apply to this model.
PROGRAM MODEL NUMBER
Model #
82
VCCC115-SS81A- CRAFT ICE
PROGRAMMING THE UNIT TO CORRECT
MODEL NUMBER
1.
Disconnect the unit from power source.
2.
Push and hold the U-Line button.
3.
While still holding the U-Line button, plug the unit into
the appropriate power source.
4.
When the flashing digits appear (3-5 seconds), use the
up and down arrow buttons to select the appropriate
model number from the chart below.
5.
Press the light bulb button once.
6.
The display will blink, and then will appear as the
programmed display.
Control Operation-Service
(5 seconds) when
or
41
Display #
Relay / Output
Option #0
Exit
Option #1
Relay 1
Option #2
Relay 2
Option #3
Relay 3
Option #4
Relay 4
Option #5
Relay 5
Option #6
Relay 6
Option #7
DC Output 1
Option #8
DC Output 2
Option #9
DC Output 3
Option #10
DC Output 4
Option #11
DC Output 5
Option #12
Serial output
(Compressor)
Relay / Output Chart
Relay 1
Compressor
Relay 2
Relay 3
Circulation Pump
Relay 4
Water Inlet
Relay 5
Hot Gas Valve
Relay 6
Cond Fan
DC1
Light 1
DC2
Light 2
DC3
DC4
DC5
Cond Fan
-
-
-
Advertisement
