Advertisement
USER GUIDE
Remove all of
the ice from
the ice bin
Lift splash shield up to access evaporator plate. Pour the
cleaning solution slowly on the evaporator plate so it
flows down into the fresh water reservoir.
Splash shield
brackets
Cleaning
Lift splash shield up to
access evaporator plate
Remove the black
reservoir drain plug
from the bottom of
the reservoir.
Splash shield
Replace the splash shield if removed.
After the cleaning cycle is completed, verify that all
build-up has been removed. If not, repeat the clean cycle
procedure.
Evaporator
plate
Grid cutter
CABINET
The painted cabinet can be washed with a mild soap and
water and thoroughly rinsed with clear water. NEVER use
abrasive scouring cleaners.
EXTERIOR
Routine cleaning of the stainless steel surfaces will serve
to greatly extend the life of your product by removing
contaminants. This is especially important in coastal areas
which can expose the stainless to severe contaminants such
as halide salts (sodium chloride).
It is strongly recommended to periodically inspect and
thoroughly clean crevices, weld points, under gaskets,
rivets, bolt heads, and any locations where small amounts
of liquid could collect, become stagnant, and concentrate
contaminants. Additionally, any mounting hardware that is
showing signs of corrosion should be replaced.
INTERIOR
Wash interior compartment with mild soap and water.
Do NOT use an abrasive cleaner, solvent, polish cleaner,
undiluted detergent or chlorine based cleaners.
23
Pour cleaning solution slowly onto
the front edge of evaporator plate
behind the grid cutter.
Advertisement
