Advertisement
USER GUIDE
Cleaning
Homes with poor water quality or high clear ice usage
might require more frequent cleaning.
To clean your ice machine you will need to purchase a
"nickel safe" ice maker cleaner.
CAUTION
!
Use only manufacturer-approved ice machine
cleaner and follow all label warnings and
directions. Incorrect chemical usage, and any
damage that may result, is not covered by
warranty.
Order ice machine cleaner online:
vikingrange.com/commercial
Part # 80-55667-00
A "CLEAN" reminder will occur every 6 months to remind
you that it may be time to clean your appliance. Over time
mineral build up on the cold evaporator plate can occur
which can adversely affect the quality of your ice. This
build-up is dependent on your water source and usage.
Normal ice production will continue while the "CLEAN"
reminder is displayed. When reset, the "CLEAN" reminder
will reset and not occur for another 6 months. If you
choose to clean the appliance at this time, see the options
menu section below.
Clean mode:
To ensure maximum performance and ice quality, it is
recommended to clean your ice machine once every six
months. This simple cleaning routine will also ensure water
and energy use continues at optimum efficiency.
Cleaning
To Clean Your Ice Machine:
1.
Turn the ice machine off by pressing and holding the
"ON/OFF" icon for 3 seconds.
2.
Remove all ice from the ice maker including from the
evaporator and grid cutter.
CAUTION
!
Forcing ice through the grid cutter will break the
grid cutter wires.
3.
Drain the water from the water reservoir by removing
the black plug from the bottom of the fresh water
reservoir.
4.
After the water is drained, replace the plug in the
bottom of the reservoir.
5.
Add cleaning solution to the evaporator plate - refer
to your cleaning solution instructions to determine the
proper amount of solution to add based on 2 quarts
(1.9 liters) of water.
6.
Turn the ice machine on
7.
Turn on clean mode by holding CLEAN for 5 seconds.
8.
Your ice maker will fill with water and circulate over the
evaporator for two 15-minute cycles then will resume
normal production.
9.
Remove the first 2-3 new batches of ice from your ice
maker before using.
22
Remove all ice from
the evaporator plate
and grid cutter area
that is not embedded
in wires
Advertisement
