Graco GM 3000 Instructions-Parts List Manual page 30

Reassembly
A
The lace
of
the housing.
A
1.41 *.010 inch (35.8
i . 2 5
mm).
A
Toque the screws to
A
CAUTION
The sprayer will be out of balance when only the
rear of the cart to prevent the sprayer from falling
over.
5. Place the
engine (48)
assembly
on
the cart. Align
the mounting holes. Carefully guide the engine
wire and wiring harness (E) from the field, through
the appropriate grommets
(50)
in the mounting
plate (A). Install the flange screws (77) and lock-
nuts
(78).
Install the screw
(61),
lock washer
(62),
and washer
(60).
Tighten all three screws. Connect
the black and white wires as shown in the Detail
drawing in Fig.
16.
120
i d b
(14
Nm).
engine and clutch housing are installed. Support the
0 the engine wire to the red wire
(a),
and connect
Fig.
22
U
30 308-620