Graco GM 3000 Instructions-Parts List Manual page 2

Table of Contents
l ~ .
' -
Warnings
......................................
2
Component Identification and Function
............
5
Setup
.........................................
6
Fueling
.......................................
8
Startup..
......................................
9
Maintenance..
................................
1 1
Troubleshooting
14
Flushing 12
Drive Housing, Connecting Rod, Crankshaft
......
16
Pressure Control
...................
i
..........
18
Pinion, Clutch, Clamp, Field, & Engine
...........
23
Pinion Housing
................................
24
Clutch
.......................................
25
Engine
.......................................
27
......................................
...............................
. . .
Field &Wiring Harness..
.......................
28
. .
Clamp
.......................................
28
Clutch Housing
...............................
28
(:
I
Reassembly
..................................
29
Displacement Pump Parts List and Drawing
37
Displacement Pump Repair.. 32
Sprayer Parts Drawing
..........................
38
Sprayer Parts List
..............................
41
Pinion Assembly Parts list and Drawing
..........
42
Pressure Control Parts list
......................
43
Technical Data
................................
44
Dimensions
...................................
44
Graco Phone Number..
........................
44
Graco Warranty and Disclaimers
................
44
...................
......
Symbols
Warning
Symbol Caution Symbol
~~~
A
CAUTION
EQUIPMENT
MISUSE
HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.
0
This equipment is for professional use only.
0
Read all instruction manuals, tags, and labels before operating the equipment.
Use the equipment only for its intended purpose. If you are not sure, call your distributor.
Do not alter or modify this equipment.
Check equipment daily. Repair or replace worn or damaged parts immediately.
Do not exceed the maximum working pressure of the lowest rated system component. Refer to the
MSTRUCMNS
Technical Data on page 44 for the maximum working pressure
of this equipment.
0
Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the Tech-
nical
Data section of all equipment manuals. Read the fluid and solvent manufacturer's warnings,
0
Do not use hoses to pull equipment.
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose
Graco hoses to temperatures above 82°C (180°F) or below -40°C (-40°F).
Do not lift pressurized equipment.
Comply with all applicable local, state, and national fire, electrical, and safety regulations.
0
Wear hearing protection when operating this equipment.
Do not use 1 ,l,l-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or
fluids containing such solvents in pressurized aluminum equipment. Such use could result in a
chemical reaction, with the possibility of explosion.
2 308-620