LENCO Classic Phono TCD-2571 User Manual page 14

• Make sure you hold the cover carefully to avoid pinching your fingers as it
closes.
LISTENING TO RECORDS
VERY IMPORTANT! (This operation only limited to the large turntable with this function)
1. Press MODE (10) (5 on remote) repeatedly to select PHONO mode.
2. Open the Record Player Cover. Release the Tonearm Clamp, and remove the stylus protector.
Place a record on the turntable, over the central spindle. Place the EP adapter over the central
spindle when playing 17cm EP records.
3. Set 33/45/78 RPM SPEED SELECTOR (34) to 33/45/78 rpm according to the record.
4. Lift the Tonearm with the Tonearm Lift Lever. Move the tonearm to the beginning of the
record, or to the start of a particular track. Gently lower the tone arm onto the record with
the Tonearm Lift lever to start playing.
5. When the record is finished the tonearm will automatically stop to the rest. To stop manually,
lift the tonearm from the record and return it to the rest.
6. Moving or jarring the turntable without securing the Tonearm clamp could result in damage
to the Tonearm. Place the protective cap on the stylus when not in use.
Installing the Stylus
1. Hold the tip of the stylus and insert the stylus by pressing as shown in direction "B".
2. Push the stylus upward as in direction "C" until the stylus locks into the tip position.
NOTES
We advise you to clean your records with an anti-static cloth to gain maximum enjoyment from
them.
We would also point out that for the same reason your stylus should be replaced periodically
(approximately every 250 playback hours)
AUX-IN
This unit provides an auxiliary audio input jack for connecting external audio device like MP3
players, CD players and allow playback of your external source through the system speakers.
Guide Pins (inside)
14