Table of Contents
Advertisement
Using the Remote with VCR or Cable TV Converter
• To control
TOSHIBA VCR, first set the TV/CABLENCR
switch to "VCR"
position. The buttons
shown below will then
control the VCR. The rest of the buttons
operate the TV as usual.
If you have another
brand of VCR, you can probably
program
your Remote to control
it.
Details are on page 11.
• To control
a cable TV converter,
this Remote Control must be programmed
to recognize the brand of your converter.
See page 11.
Set the TV/CABLENCR
switch to "CABLE"
position
whenever
you control the cable TV converter.
Aim at the VCR or cable TV converter
m
m
m
TV/CABLENCR
switch
"CABLE"
: To control cable
TV converter
"VCR" : To control VCR
Channel number buttons
Press the numbers
desired for direct access.
STOP button
Press to stop the tape.
REC button
Press to start recording.
TV/VCR button
Press to select the TV mode
to view one program
while
recording
another
program.
J
EDS
ADV
REC
TV/VCR
REW
FF
TOSHIBA
--
POWER button
Press the button to turn the
VCR (or converter)
on.
Press again to turn off.
CHANNEL A/•
buttons
Press •
button to select next
higher channel.
Press •
button to select next
lower channel.
CH RTN button
See page 18.
PLAY button
Press to begin tape playback.
FF button
Press to rapidly advance the tape. In
playback mode, press to view the picture
moving rapidly in forward direction.
REW button
Press to rewind the tape.
In playback
mode, press to
view picture
moving
rapidly in
reverse.
Shaded
buttons can be used to control
the cable TV converter.
10
Advertisement
Table of Contents
