Converter - Toshiba CF32H40 Owner's Manual

Using the Remote with VCR or Cable TV Converter
w ....
• To control a TOSHIBA VCR, first set the TV/CABLENCR switch to "VCR" position. The buttons shown below will then
control the VCR. The rest of the buttons operate the TV as usual.
If you have another brand of VCR, you can probably program your Remote to control it.
Details are on page 11.
• To control a cable "IV converter, this Remote Control must be programmed to recognize the brand of your converter.
See page 11. The shaded buttons can be used to control the cable TV converter.
Set the TV/CABLENCR switch to "CABLE" position whenever you control the cable TV converter.
Aim at the VCR or cable TV converter
Channel Number buttons
Press the numbers
desired for direct access.
m
m
m
TV/CABLE/VCR switch
"CABLE": To control the
\
cable "IV converter
"VCR": To control the VCR
TV/VCR button
Press to select the TV mode to
view one program while
recording another program.
REC (record) button
Press to start recording.
SLOW button
Press to view a slow-motion
picture in playback mode.
PAUSE button
Press to freeze the picture
during playback or recording.
Press again to release.
SLOW PAUSE REW FF
POWER button
Press the button to turn the
VCR (or converter) on.
Press again to turn off.
ENTER button
Some VCR's and'cable TV
converters require "ENT" to
change channel number.
-- CHANNEL • / • button
Press • to select next higher
channel.
Press • to select ne_t lower
channel.
STOP button
Pressto stop thetape.
PLAY
Press to begin tape playback.
FF (fast forward) button
Press to rapidly advance the tape.
In playback mode, press to view
the picture moving rapidly in
forward direction.
REW (rewind) button
Press to rewind the tape.
In playback mode, press to
view picture moving rapidly in
reverse.
10