Table of Contents
Advertisement
Using the Remote with VCR or Cable TV Converter
ө To control
a TOSHIBA VCR, first set the TV/CABLE/VCR switch to "VCR" position. The buttons shown below will then
control the VCR. The rest of the buttons operate the TV as usual.
If you have another brand of VCR, you can probably program your Remote to control it.
Details are on page 9.
ө Tocontrol a cable TV converter, this Remote Control must be programmed to recognize the brand of your converter.
See page 9. The shaded buttons can be used to control the cable TV converter.
Set the TV/CABLE/VCR switch to "CABLE" position whenever you control the cable TV converter.
Aim at the VCR or cable TV converter
LIGHT RECALL
POWER
~ DOO
CABLE
MUTE TVMIDEO C.CAPT
POWER
Press the button to turn the
VCR (or converter) on.
Press again to turn off.
TV/CABLE/VCR switch
"CABLE"
: To control
cable TV
converter
"VCR" : To control VCR
CHANNEL A/V
Press A button to select next
higher channel.
Press V button to select next
lower channel.
Channel Number
Press the numbers
desired for direct access.
ENT
Some VCR's and Cable TV
converters require ENT to
change the channel number.
PLAY
Press to begin tape playback.
STOP
Press to stop the tape.
REC
Press to start recording.
FF
Press to rapidly advance the tape. In
playback mode, press to view the picture
moving rapidly in forward direction.
TV/VCR
Press to the TV mode to
view one program while
recording another
program.
TOSHIBA
CT-9904
REW
Press to rewind the tape.
in playback mode, press to
view picture moving rapidly in
reverse.
Advertisement
Table of Contents
