Table of Contents
Advertisement
Em e rg e n cy assis t a n ce
Emergency
assistance
Vehicle
jack,
vehicle
tool
kit and collapsible
spare
tire
Onboard tool kit and vehicle jack
The vehicle tools and vehicle jock* ore stored in
the luggage comportment under the floor cover.
Fig. 207 Luggage compartment:
on board too l kit and vehi-
cle jack
The vehicle jack* is stored under the onboard tool
kit ¢ fig. 207.
Hybrid drive*: the storage location of the on-
board tool kit varies
r:!)
page 107.
The onboard tool kit includes:
- Hook for removing wheel covers*
- Plastic hook to remove wheel bolt covers*
- Alignment pin for changing wheels
- Wheel bolt wrench
- Folding chocks
- Screwdriver with reversible blade
- Socket (removable Torx socket)*
- 10 x 13 open ended wrench (for disconnecting
the battery cables)
- Towing eye
A
WARNING
Improper use of the vehicle jack* can cause
serious personal injuries.
- Never use the jack* supplied with your Audi
on another vehicle, particularly on a heavier
one. The jack* is only suitable for use on the
vehicle it came w ith.
250
- Using a bumper jack to raise the vehicle will
damage the bumper system. The jack may
slip, causing injury.
- Never support your vehicle on cinder blocks,
bricks or other objects. These may not be
able to support the load and could cause in-
jury when they fail.
- Never start or run the engine while the vehi-
cle is supported by the jack* .
- If you must work under the vehicle, always
use safety stands specifically designed for
this purpose.
- Never use the hexagonal socket in the han-
dle of the screwdr iver to loosen or tighten
the wheel bolts .
- Always make sure the inflatab le spare tire*
and even a flat tire are secured in place and
not loose, otherwise they could fly forward,
causing personal inj ury to passengers in the
vehicle in an accident or sudden maneuver.
@
Tips
The vehicle jack in your vehicle is mainte-
nance-free.
Folding chocks
The folding chocks ore port of the on board tool
kit .
--
-
Fig. 208 Open ing folding chocks
To use the chocks, you fi rst have to raise the sup-
port plate
¢
fig. 208
(D
and then insert the lock-
ing plate with the two "tabs" into the elongated
holes in the base plate
@ c>
&..
.,,_
Advertisement
Table of Contents
