Electrolux Tappan Owner's Manual page 15

General Cleaning
(continued)
When lowering the top,
grasp the sides with fingertips only. Be
careful not to pinch fingers. Also, DO
NOT drop or bend the rangetop when
raising or lowering. This could damage
the surface.
Hold coo_op
flat to remove
DO NOTturn the burners
on when the cooktop is raised for
cleaning, Besurethatthe top iscompletely
lowered and securely in place before
turning on the burners.
Use the finger openings along the
outside edges of the oven bottom to
raise and lower the oven bottom.
To Raise and Lower the Top for Cleaning
1, Remove burner grates and spiltover bowls. Set aside.
2, Grasp the front of the cooktop and then lift.
3, Lift the top high enough to fully raisethe support rods, The Uft-up rods will
support the top in its raised position.
4. Clean underneath using hot, soapy water and a clean cloth; then, dry.
5, Lower the top gently after lowering the support rod.
To Remove and Replace Burners for Cleaning
Your model wit! have one of the two burners types shown below, Follow the
instructions that correspond with the burners on your range.
Figure 1
Figure 2
._ i ¸
To Remove Burners (Figure 1)
1. Removeshipping screws with a Phillips® Head screwdriver. See illustration for
screw locations.
2. Tilt the burner at the end closest to the support bar until the locator tab is
released(front burners tilt right, rear burners tilt left). Move it toward the back
of the range. This will separate it from the gas valve at the front of the range.
To Remove Burners (Figure 2)
I. Removeshipping screws with a Phillips® Headscrewdriver. See illustration for
screw locations.
2. Lift burner pair straight up and out of range.
To Replace Burners (Figure 1)
1. Slide the burner tube over the gasvalve at the front of the range (front burners
fit over the right valve, rear burners fit over the left valve on each side of the
range).
2. Tilt burner so that the locating tab will slide into the s!ot on the support bar.
Make sure burners are properly seated on support bar and are level.
3. Replaceshipping screws if desire&
To Replace Burners (Figure 2)
1, Placeburner pair over mounting bracket, Makesure burners are positioned over
gas valves and are properly positioned and level.
2. Replaceshipping screws if desired.
To Remove and Replace Oven Bottom
To Remove the Oven Bottom:
Using the finger openings on each side of the oven bottom, pull out and lift up the
oven bottom.
To Replace the Oven Bottom:
1. Graspthe oven bottom and position the front tabs in place in the slots at the
rear of the oven.
2. Lower the front of the oven bottom and slide into place.
15