Table of Contents
Advertisement
1. Introduction
The manufacturer innovateIT Car Wash Equipment LLC is committed to the continuous improvement of its equipment
construction quality and the safe operation of its equipment.
1.1 Warranty
This manual covers the installation, intended use, and maintenance of the Reverse Osmosis (RO) Spot-Free Rinse System.
Misuse or improper operation of this device will void the manufacturer's warranty.
A 1-year limited warranty from the shipping date covers this product. This warranty shall be void and of no effect if:
•
Any installation defect that was apparent or ascertainable at the time of installation was completed but was not
promptly reported to innovateIT Car Wash Equipment LLC.
•
Damage occurs due to the customer's failure to observe any instructions from innovateIT Car Wash Equipment or an
authorized distributor and/or requirements of the manufacturer with respect to the product.
•
The breach results from misuse of the equipment as outlined in the instruction manual.
When purchasing through a distributor, please ask about their warranty coverage on the unit.
1.2 Safety Information
FAILURE TO FOLLOW INSTALLATION AND OPERATING INSTRUCTIONS MAY RESULT IN DAMAGE TO EQUIPMENT OR
The instructions in this manual provide you with the information necessary to install and operate the R.O. System. Before
starting installation, the instruction manual should be carefully read and understood. This relates to all Reverse Osmosis
Spot-Free Rinse System documents from innovateIT Car Wash Equipment.
The basic pre-requisite for safe working is compliance with all the safety and handling instructions stated in this manual.
Furthermore, follow all local accident, hazard prevention regulations or general safety regulations when installing and operat-
ing the R.O. System.
The equipment's operation, maintenance, and troubleshooting must only be carried out by trained personnel. Personnel be
able to interpret a wiring diagram, use a multimeter to read AC and DC, and apply Lock Out Tag Out safety procedures specifi c
to the equipment.
Eye protection should be worn at all times when operating the RO. System, as the unit includes high pressure water lines and
membrane housings which may leak if fi ttings loosen over time.
Electrical installation must adhere to local codes and the National Electrical Code, ANSI/NFPA 70 for electrical wiring. To avoid
electrical shock hazards, do not operate this device when controller enclosures are open and energized. Electrical power must
be shut off and a lock-out procedure utilized to ensure all electrical power is disabled before performing maintenance to any
4
|
Introduction
Introduction
Section Header
CAUTION!
PERSONAL INJURY.
Advertisement
Table of Contents
