Mitsubishi Electric EHPT17X-VM2E Service Manual page 36

Quick start
When the main remote controller is switched on for the first time, the screen automatically goes to the [Language], [Date/Time], [System configuration], and quick start
setting screen in order. On the quick start setting screen, the following items can be set.
Note:
[Electric booster heater use]
This setting restricts the booster heater capacity. It is NOT possible to change the setting after starting up.
If you do not have any special requirements (such as building regulations) in your country, skip this setting (select [Next]).
Quick start
• [Zone sensor selection]*1
• [Emitter selection]
• [Control logic]
• [Outdoor design temperature]
• [Zone sensor selection]*2
• [DHW]
• [Flow rate & pump speed]
• [Electric booster heater use]*3
*1 Selection of zone to assign each wireless remote controller
*2 Selection of room sensors for monitoring the room temperature
*3 It cannot be reset, so be careful when you set it.
Lock menu
Pressing and holding the menu icon
(The icon changes to when the lock menu is on.)
Some functions cannot be edited in this state.
Note: You need a password to edit [Service] even when the lock menu is off.
Refer to the main controller menu tree for details of the items which cannot be
edited when the lock menu is on.
<Main Controller Menu Tree>
[Home screen]
[DHW]
[DHW1/2]
[Next]
OCH814A
for 3 seconds switches the lock menu to on.
[Eco] ( / )*
DHW Target temperature ( + / - )*
Edit*
[Boost] (Start / Cancel)
[DHW2/2]
[Legionella] (
Target temperature ( + / - )*
[Schedule] (
[Always off] (
Back
Skip
Back
Zone
Zone
Zone
Zone
Zone
°C
°C
When the system is started up for the first time, the quick start
setting screen appears.
The items with an asterisk (*) cannot be edited when the lock
menu is on. (The icon changes to
[Max. temp. drop] ( + / - )
[Max. operation time] ( + / - )
[Interval] ( + / - )
[Volume] ( + / - )
/ )*
[Start time] ( + / - )
Edit*
[Duration] ( + / - )
[Frequency] ( + / - )
[Max. operation time] ( + / - )
/ )
/ )
36
Pair wireless sensors
Begin quick start?
Yes
Emitter selection Next
[Emitter selection]
Zone DHW
°C °C
+
°C °C
[Home screen]
when the lock menu is on.)
Note: State description indicated by toggle
Active; , Inactive;
Schedule setting
Edit*
Next
setting
Press and hold
the icon for 3
seconds.
Lock