Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Eaton UM15
Summary of Contents for Eaton UM15
- Page 1 UM15 Filter unit Operating Instructions Version 1.1 Version valid from: 1/22/2024...
-
Page 2: Table Of Contents
Table of Contents SAFETY INFORMATION 1.1. Signal word list ....................3 1.2. Safety instructions ..................... 3 1.3. General provisions ..................... 4 1.4. Intended use ....................... 4 1.5. Areas of application—compatibility ..............4 TECHNICAL DATA COMMISSIONING 3.1. Initial and idle condition ..................5 3.2. -
Page 3: Safety Information Signal Word List
The UM units are not suitable for the treatment of water- based liquids! In the event of leaks, collect the oil using proper methods (oil binding agents). The UM15 units are suitable for indoor use only and must not be installed outdoors! -
Page 4: General Provisions
The UM15 circulating filter units remove oil from a container connected via a hose line in order to clean it of dirt and water. The cleaned oil is pumped into the designated container. -
Page 5: Technical Data
Technical data Pump performance: 15 L/min at 2800 rpm E-motor: 0.18 KW, 2800 rpm Alternating current: 230 V, 50 Hz Compressive load capacity: max. 4 bar Filter fineness: 10 μm(c) Weight: approx. 14 kg Operating medium: see 1.5; 10 to 400 mm²/s Other media on request Commissioning 3.1. -
Page 6: Reaction In The Event Of Faults/Troubleshooting
OFF - ON switch Motor- protective circuit-breaker 3.3. Reaction in the event of faults/troubleshooting The motor-protective circuit breaker serves as overload protection for the electric motor, disconnecting it from the supply voltage in the event of an overload. This can occur if the current consumption of the electric motor is too high: When taking in cold oil •... -
Page 7: Replacing The Filter Cartridge
3.4. Replacing the filter cartridge The filter cartridge must be changed when contamination of the filter cartridge is signaled by the contamination indicator "O" on the filter (red display field). The filter cartridge must be changed when the filter unit is in the idle condition (device plug disconnected from the grid). -
Page 8: Declaration Of Conformity
Declaration of conformity... - Page 9 Tel: +65 6825-1620 others is beyond our control, no guarantee, expressed or Friedensstraße 41 implied, is made by Eaton as to the effects of such use or 68804 Altlußheim, Germany the results to be obtained. Eaton assumes no liability arising out of the use by others of such products. Nor is the...
Need help?
Do you have a question about the UM15 and is the answer not in the manual?
Questions and answers